Ebara 80×65 FSD4GA5.75 mono block end suction pump.
Features :
- Motor closed couple, alignment free construction
- Easy maintenance BPO (Back pull out) feature allows all rotating element to be removed without disconnecting the suction and discharge pipework
- Top centerline discharge, foot support under casing for maximum resistance to misalignment and distortion from pipe loads
- Higher operating efficiency over a wider range of capabilities, lowers operational cost
- Very compact design for ease of installation and permits minimum maintenance
Applications :
Ebara 80×65 FSD4GA5.75 can be used for :
- water supply
- hot and cold water circulation
- for cooling tower
- fire – fighting application
- irrigation
- industrial use
- drainage
- sprinkling
- air-conditioning
- for swimming pool
- brine
- oils
Specification :
- Model : FSDA
- No. of pole : 4
- Liquid Handled :
Type f liquid : clean water
Temperature : 0 deg. C – 100 deg. C (32 – 212 deg. F) - Maximum positive suction : All except FSLA : 8.2 – (Shutoff pressure)
Pressure (Kg/ cm²) for Mechanical seal : FSLA : 10.2 – (Shutoff pressure) - Maximum working pressure : 10.2 Kg/ cm² (10 bar)
- Available suction lift : Suction <=125 : 6m ; 125 x 100 : 4m
- Synchronous speed : 1450 min¯¹
- Location : Indoor, Optional : Outdoor
- Construction :
– Shaft seal : Mechanical seal
– Pump shaft : Stab shaft - Material :
– Casing : cast iron
– Bracket : Cast iron
– Impeller : bronze
– Shaft : 316 stainless steel
– M. seal : Ceramic vs carbon - Flange :
– Suction : JIS 10 KRF
– Discharge : JIS 10KRF
Motor :
- Type : IEC standard flange type
- No. of pole : 4
- Synchronous speed : 1450 min¯¹
- Insulation class : F
- Protection : IP 54, Optional : IP 55
- Voltage/ phase/ Hz : 380 V/ 3 phase/ 50 Hz
- Material frame : Cast iron