Piston Pump Yuken A16 In the A16 pump, The efficiency properties in case of “A16” pump are high efficiencies to be shown below. the noise level is as low as 57.3 dB(A).
Hydraulic Fluids :
- Hydraulic Fluids. use petroleum based oils such as anti wear type hydraulic oils equivalent to ISO VG-32 or 46.
- Control of Contamination. Due caution must be paid to maintaining control over contamination of the operating oil which can otherwise lead to breakdowns and shorten the life of the unit.
Intruction :
- Mounting. When installing the pump the filling port should be positioned upwards.
- Alignment of Shaft. Employ a flexible coupling whenever possible and avoid any stress from bending or thrust.
- Suction Pressure, Permissible suction pressure at inlet port of the pump is between -16.7 and +50 kPa.
- Hints on piping, When using steel pipes for the suction or discharge ports, excessive load from the piping to the pump generates excessive noise.
- Suction Piping, In case the pump is installed above the oil level.
- Drain Piping. Install drain piping according to the chart and ensure that pressure within the pump housing should be maintained at a normal pressure of less than 0.1 MPa and surge pressure of less than 0.5 MPa.
Features :
- High Efficiency. The efficiency properties in case of “A16” pump are high efficiencies to be shown below.
- Low noise level. In the “A16” pump, the noise level is as low as 57.3dB 9(A)
- Accomplishment of energy saving. Because the overall efficiency is high and the cut-off characteristics is sharp, thus the input power may be saved.
- Low heat generation. Because of small power loss, it is possible in oil temperature. accordingly, capacity, be reduced.
Specification :
- Model Numbers : A16-*-R-01-*-*-K-32
- Geometric Displacement : 15.8 cm3/rev
- Minimum Adj. Flow : 4 cm33/rev
- Operating Pressure : Rated : 16MPa, Intermittent : 21MPa
- Shaft Speed Range : Max. 1800 r/min, Min. 600 r/min
- Approx : Flange. 16.5 kg, Foot. 18.7 kg