Torishima Pump CAL 50-250 end – suction volute pump cast iron applied for :
- Utility :
– Co-generation : Cooling water pump, Hot water (circulation) pump
– Air conditioning : Cold water pump, cooling water pump, hot water pump - Iron and Metal
– Power generation : Deaerator feed water pump
– Hot rolling : transfer pump, hot water pump, water pumping pump, filtrate pump, back wash pump - Food and Beverage
– Manufacturing process : Cold water pump, cooling water pump (circulation, boost), recycle water pump, filtrate pump, sprinkling pump
– Refrigerator : Chilled pump, defrost pump - Garbage Incinerating Plant :
– Power generation : Deaerator feed water pump, condensate pump
– Heat decrease tower : Heat decrease pump, spray pump for heat decrease tower
– Drainage : Reuse water pump (pumping, transferring, feeding)
Specification of Torishima Pump CAL 50-250 end – suction volute pump:
| Handled liquid | Kinds : Clean water, warm water, oil, chemical medicine, alkaline solution, brine, heat transfer media, abrasive slurry liquid under 3wt%, etc. Temperature : Standard : -10 deg. C < T ≼ 100 deg. C Option : 100 deg. C < T ≼ 350 deg. C |
| Maxi. discharge pressure | Standard : 1Mpa (10kgf/cm²G) Option : 1.4MPa (14kgf/cm²G) |
| Maximum suction pressure | 0.8MPa (8kgf/cm²G) |
| Design | Impeller : Closed Shaft seal : – Standard : Single mechanical seal (rubber bellows) – Option : Double mechanical seal, gland packing Water Injection for shaft seal : – Standard : Internal injection – Option : Quenching, flushing Lubricated bearing : Standard : Grease lubrication Option : Oil lubrication |
| Flange standard, Suction/ Discharge direction | JIS 10KRF Shaft direction suction/ Vertical top discharge |
| Pump Material | Casing : FC250 (standard), FCD400 (Optional) Impeller : FC200 (standard), SCS13, SCS14, BC6 (Optional) Shaft : SUS420J2 (standard), SUS329J1, SUS304 (Optional) Case wear ring : FC200 (Standard) |